03-08-2019 07:57 AM
03-08-2019 11:49 AM
Greetings.
From the CIMC, take a look at the SEL log, to see if it shows any components failing (i.e. DIMMs or Processor).
If the server is not getting past post, how are you updating the CIMC/BIOS with the HUU mounted ISO?
You might want to remove Proc #2, and DIMMs in Proc#2 dimm banks, along with all but DIMM in slot A1, to see if a hardware issue is causing the post stall.
If you are still under a support contract, I would open a TAC case.
Kirk...
03-11-2019 06:35 AM
Hi krik ,
-i updated BIOS with recovery.cap not by HUU.iso mounted, i used getfw
-in log i have CATERR_N: A catastrophic fault has occurred on one of the processors: Please check the processors' status.
can I test with a single proc, to do the diagnosis?
attached : technical support file
Thanks in advacned for your kind support. Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide