Hi
I am testing a isr router with a ucs blade installed but seem to run into some issues. I have the router directly connected to my laptop and are follow the configuration instructions in the configuration guide. I get the following symptoms in any of the configuration / connectivity scenarios…. connecting to one of the router port and mapping that to the ucs, connecting to port g2 on the ucs or connecting directly to the management port. I do configure the unit with the appropriate configs for each of the connection types as per the guide.
Problem 1 – although I am able to ping both the router and the cimc IP I cannot web to the cimc.
Problem 2 – if I try to install esxi (same as I run on our B and C series servers) it gets to about 75% and then halts looking for a network card.
I am obviously missing something here… any assistance will be appreciated
Regards
