Upgrade memory on ucs-c220

[Jose Luis Pinto Monteiro Alves]

Hi,

I have a server with 80Gb Memory installed(10x8Gb)

Now i tried upgrade memory installing two slots about 32Gb (2X32Gb)

The configuration i tried was:

CPU1 - 6*8GB (Slot A1A2B1B2C1C2)

CPU2 - 2*32Gb (Slot E1 F1) and another try on Slot E1 E2. Both fails

System stops at boot in testing memory.

Can someone help me?

Thanks

[Kirk J]

Please review the memory population rules at http://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-c-series-rack-servers/c220m4-sff-spec-sheet.pdf  or if c220m3

The CPU 1 & 2 memory layout needs to mirror each other exactly.

You also need to fill out the first bank before moving to the next (i.e. A1-D1 before populating A2-D2).

I would also put the higher capacity DIMMs in A1, E1.

I am assuming the DIMMs are all of the same type, and are supported PIDs listed on the previously referenced spec sheet?

If you have a question about individual DIMM health,, I would start with populating just A1 and E1 slots,, and see if the server passes POST checks.

Thanks,

Kirk...