Vnic0

[mabuhantash]

can you privde me for basic troubleshootings steps for major fault when create Server from service proficle for vnic 0 , adapter link down ?

major,F0207,49182,sys/chassis-1/blade-1/adaptor-1/host-eth-1/fault-F0207,link-down,2010-12-12T14:20:39,Adapter  host interface 1/1/1/1 link state: down

major,F0479,49181,sys/chassis-1/blade-1/adaptor-1/host-eth-1/vif-685/fault-F0479,vif-down,2010-12-12T14:20:39,Virtual interface 685 link state is down

could you have any suggestion on that for troubleshooting ??

[Jeremy Waldrop]

When you created the vNIC did you put it on Fabric A?

[mabuhantash]

I am not sure I see that option , but I think I do it , I create it using the expert wizerd .

if I want to modify it can I modify it. but I think it is A. if it is not on A this may be the issue . but if it is on A.

what athor causes can be in account for that .??? note that I have 1 I/O module only I can connect one cable for I/O 1.

the other cable try to connect it but it give me link down , I try change it through Global policy but no success.

also the fist port of I/O Module 2 is Up even it is not connected to UCS6120XP.

thanks for the help

best regards

[mabuhantash]

sure It is on A , I think also the VHBA created does not send traffic ????

I installed ESX I can see the nic but no traffic out , the adapter link down.....any suggestiones

[Jeremy Waldrop]

Do you have a northbound Ethernet switch connected to your 6120?

[mabuhantash]

the UCS 6120XP FABRIC A connected to catalyst-6513 throoug 1 Gpbs port 1/2 , and it shows UP. ?? dotq1 and fastport, please note also the Vhba is not login to MDS fabric also the FC uplink is login in the Flogi?? I use VLAN 29 as fabric a ant it is used in the DC

the adapter link down , and the I/O is amber on both, and one of them inaccebilty, ??? is that may help  , is there settings on flex needed to disable the other module ???