Zoning, direct attached Netapp

[Walter Dey]

UCS V2.2.1b, FC switch mode, Netapp filer direct attached with FC.

SP with 2 vhba, one mapped to fabric A resp.B., 2 FC target end point, one in fabric A, resp. B.

If I check the zoning done by UCS, I actually see 4 zones (SIST) ? why ? I would only expect 2 ??

        

[Manuel Velasco]

The additional zones get created because of the wwpn targets added in the boot order policy. If you remove or add more targets it will add or remove additional zones