cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
228
Views
0
Helpful
1
Replies

adding cisco UCS in SOLOADWINDS or dcnm with snmp version 3

SNMP V3 Not working

Hi,

I have cisco UCS 6200X. I want to set up SNMP v3 on it and add it to SOLARWINDS software.

But I can not add it to SOLARWINDS software with SNMP v3 and the problem. I tested in another software (snmpwalk) and it was still does not work. Is there a special configuration reqired?

Please help me.

regards

ALI

 

Everyone's tags (2)
1 REPLY 1
Highlighted
Cisco Employee

Re: adding cisco UCS in SOLOADWINDS or dcnm with snmp version 3

Greetings.

Common issues we see customers run into for SNMP V3 config:

  • Creating SNMPV3 user account that is the same as another local account (i.e. admin)
  • Cisco UCS Manager Release 3.2(3) and later releases do not supportSNMPv3 users without AES encryption.
    • make sure you enable AES-128 encryption
  • Port 161 is not open on firewalls for Both FI nodes and VIP IP addresses
    • confirm you can reach the UCSM with SNMP v2, and a community string set.
    • run ethanalyizer on the Primary FI from the NXOS
      •  ethanalyzer local interface mgmt capture-filter "port 161" limit-captured-frames 0 detail

      • This should show if the snmp queries are even getting there, have the right community string, and if the UCSM is responding.

 

https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/System-Monitoring/3-1/b_UCSM_GUI_System_Monitoring_Guide_3_1/b_UCSM_GUI_System_Monitoring_Guide_3_1_chapter_0101.html

 

Thanks,

Kirk...

CreatePlease to create content