*Keep in mind that is for M6 only and SW release 4.2(1) or later.
A new version of the script is posted below (v3). This version adds additional support for UEFI boot on UCS Rack Servers.
About the Cisco Standalone C-Series Host Update Utility USB Image Utility:
This utility is designed to assist users who want to update firmware on their standalone C-Series server from a USB drive. Specific, this utility will write the HUU ISO image to a bootable USB stick. This USB stick can be used to update firmware on a standalone C-Series server either by changing the boot order or manually selecting the USB device in the <F6> boot menu.
Requirements: - HUU USB Image Utility - Linux Server (Tested with RHEL 6.4 and CENTOS 6.4) - The following package must be installed: syslinux-4.02-8.el6.x86_64 (or later) - Standalone C-Series HUU Image (to be written)
Note: You may need to unmount the drive to properly execute the script. (umount <dev>)
sh create_util_usb_v2.sh <UCSB Device> <file.iso>
OR sh create_util_usb_v2.sh /dev/sdb ucs-c240-huu-22.214.171.124.iso
Hello,this is FI #2 for our 2nd UCS BladeCenter and the firmware update got stuck in the state of rebooting. Now the FI is 100% bricked -- as I took a look at it's LEDs few days later I realized, that Eth Ports were online, but all the SFP connectors...
I have some older N20-C6508 chassis, which I understand are still supported. I would like to run UCSB-PSU-2500ACDV PSUs on the same chassis as UCSB-PSU-2500ACPL PSUs. Is this possible? Or is it at least possible to keep the chassis runni...
Actually, this question is directed squarely at the HyperFlex developers, so if you know anyone in that camp, please ask them to read this.
Do Snapshots contribute to the deduplication savings in HXDP?
The evidence I've gat...
Hi dear Does anyone know how i configure unsupported transceivers on a FI? For a catalyst switch the command would be "service unsupported-transceivers" what would it be for the FI CLI? Have a great day
Hi,I'm having an issue configuring and accessing the CIMC on a UCS-E160S-M3/K9 running inside a Cisco ISR 4351.I have it configured like this:ucse subslot 1/0imc access-port shared-lom te2imc ip address 10.199.30.5 255.255.0.0 default-gateway 10.199....