configure port channel between IO Module and FI

[amoussaPersonal]

                   Hi,

I have the current setup

UCS chassis (4 uplinks) --> FI --> (Port channel) --> N5K --> (port channel) --> VSS 6500

I configure port channel between IO Module and the FI by changing to policy to "Port Channel" and set the link to 4

FI has created a portchannel under "Internal" containing all the FI interfaces that are connected to the IO module.

I have installed ESXI on a blade but i was unable to reach it, even the esx was unable to ping the gateway.

VLAN tagging is enabled from the ESX server.

I have issued the command "show mac address-table | inc <mac address of the vnic assigned from thre service profile> on both the N5K and thr 6500 and the mac is there.

I have allowed all the vlans on the vNIC from the service profile.

am I missing anything?

thanks

[padramas]

Hello,

Can you please check whether your ESXi vmkernel interface ip address learned on right VLAN on FI / upstream switch or not.

connect nxos

show mac-address-table | inc 

Padma