Connecting a modem to the console is not an issue, would be same as modem to Nexus 5K console port, As stated in the N5K hardware guide "The console port can be used to connect to a modem. If you do not connect it to a modem, connect it either before powering the switch on or after the switch has completed the boot process" This is due to setup script. Use the proper DCE connections
The better place to place a modem would be on a terminal server connected to both 6100 FI's allowing access from ethernet and dial-in
There is a prevalence of network threats across the world, and the rate, at which these threats continue to emerge, is more rapid than ever before. Cisco Next Generation Firepower (CNGFW) security technologies is information security service that provides...
Upload the Script to Datastore
1. Browse to any Datastore of ESXi Host2. Upload the folder "lsigetvmware_022817" ex. Suppose the datastore name is "Datastore3"
Run the Commands
Enable SSH of ESXi Host
SSH to ESX...
SymptomsCisco Prime is unresponsive. Web GUI will not load. Device doesn't respond to ping.DiagnosisPrime chassis is off.SolutionSince the CIMC uses Flash you can no longer use your bowser. SSH to CIMC address instead. show chassis detailChassis:Powe...
Very first data cloud — Evolution of data lake to hybrid cloud
Today, in this digitized world, data is being generated at a very high rate and from many different sources, and it is growing exponentially in many use ca...
PXE (Preboot eXecution Environment) Server allows unattended or automated OS installation over the Network. The main benefit of pxe is that we don’t need any bootable drive to boot OS(Operating system) and we do not need to to burn any ISO file into DVD o...