what is the version of code running - You can try either below method that should work for you :
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/ts/guide/trouble.html
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/3-1-1/s...
check the below thread to find out more about what caused the issue :
https://community.cisco.com/t5/cisco-bug-discussions/punt-inject-5-drop-punt-cause-punt-cause-policer-drop-packet/td-p/3959555
Hello support
i am not sure iam the one who facing the issue, but i checked same time on mobile i see the same time
i am based at +0:00 BST - around 8 am to 9 am between the community site losing the connection in the middle of my comments, and a...
Looking to deploy in production environment, Default Catalyst 9300 ship with Everest-16.6.3 ED.
what is the difference here - which one got more advantage, i know Everest is the answer, if that is answer Why Fuji ?
aaa server radius dynamic-author - This enables ISE to act as an AAA server when interacting with the client
Enters dynamic authorization local server configurationmode and specifies a RADIUS client from which a device accepts Change of Authorizatio...
best is boot from USB and try format the flash and load the image
https://community.cisco.com/t5/networking-knowledge-base/the-quot-device-does-not-contain-a-valid-magic-number-quot-error/ta-p/3132124
https://www.cisco.com/c/en/us/support/docs/switc...
There are some tools used long back ACS to ISE 2.X version, but sure ISE 3.0 changed lot now
check some guide help you :
https://www.youtube.com/watch?v=YFobxmbeC-8
yes i have seen this issue when you remove - it has removed asic associated interface, have no clue that time it was almost all 5 years or more. i have to put manually back the config back in to interface especially QOS config.
May be if the feature ...
how is your configuraiton of the port connected Opensese FW - can you post that config.
if the switches actiong Layer 2 then that should work - its bizzar , by the way what is the DHCP Server or opensese Server IP ?
try adding VLAN 1 also in the allo...