Hi @shivam ojha ,This is normal behavior. The PEs loopback interface address are reachable from the global routing table, not the VRF.If you want to ping from PE1 to PE2 using the VRF CUST-1, you need to ping from and to and address that lives in the...
Hi @steven.crutchley ,> The down-bit does not apply to Type 3 LSAs.I think you meant down bit does not apply to type 5 LSA.The way to fix the issue in this specific scenario would be to set the administrative distance higher for the OSPF external rou...
Hi @steven.crutchley ,You would indeed need to run ospf as a PE CE protocol between PE1 and CE1 for the automatic loop prevention to take place on PE2 and PE3.Just as a precision, the down bit would be used only for OSPF LSA type 3. For OSPF LSA type...
Hi @n_abromov ,It is normal behavior for the BGP LU allocated label is not from the SRGB. The BGP LU label is allocated locally on PE2 from a separate pool and advertised to PE1.Regards,
Hi @Mr.Kumar ,I do not think these commands will reset the session, but it is safer to implement these changes inside a maintenance window.BTW, it is always a good idea to do a "clear bgp ipv4 uni * soft in" after you modify the inbound policy.Regard...