HiProductsIBM Server with Ethernet Server Connectivity Module, 6 GB Ethernet ports - Qty 1Cisco 6509 - Oty 02Cisco 4948 - Qty 02Earlier setup: IBM server was connected to 6509-1 and 6509-2 and both switches were connected over a trunk link. Everyth...
I have two routers connected to two different ISPs. On LAN side both the routers are connected to two L3 switches. On L3 switches users/web servers are connected. I have APNIC IP addresses and AS number with me. Both ISPs will provide me default ...
Hi AllI have cisco devices with "aaa-new model" enabled on it. But I don't have Cisco ACS. Now my requirement is to enable my devices such that if I put wrong username, it must not prompt for password.RagardsBSN
HiMy requirement was to run QoS on ethernet sub-interface. To achieve that I have configured the shape (percent) command, in "child" (nested) policy maps, on Cisco 7200. IOS: c7200-adventerprisek9-mz.124-15.T1.binNow after applying the policy on su...
Hi AllCisco TAC finally released a SMU to fix the problem. It seems MPLS package isn't enabled by default (IOSXR - 7.2.2). To identify the problem, try to run following commands:show ETHer-ea interface bundle-ether 1 location 0/rp0/cpu0 | i MPLS >...
Hi HaroldThe scenario is quite similar AGG01<-> Pre-AGG01 <->Pre-AGG02 <-> Pre-AGG03 <-> AGG02. All are running ISIS, SR and iBGP between AGG and Pre-AGG routers (No BGP between Pre-AGGs). AGG routers are acting as Route Reflectors for Pre-AGG route...
Hi HaroldThanks for your feedback on this case so far. I was helpful. Just checking, if you found some answer to your query or have some update on this topic.Regards/Bharat
