Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Expert I'm using windows server nps and using c2960 in a lab, I have a laptop connected to the port and auth success.but the port keeps jumping to the voice domain, even I use the 802.1x to assign the VLAN for the port, it still remains on the d...
Dear Sir/MadamI have a strange issue with the vlan on SG250.I have a proper vlan configuration, and disable gvrp.but my vlan config will auto change after reboot.for what I find now, it success to load the vlan config during startup.but when it detec...
I'm new for the radius in cisco and I wish someone can give me some idea I'm using our windows server as a radius server to do the port authentication.Recently, I had a project to create a redundancy server for the port authentication. I'm using ...
Dear All, I would like to know if there any way to implement 802.1x authentication for the VOIP Phone and PC at the same time? My current infrastructure is, Avaya Phone: 1603 and 1608,I have voice VLAN for the phone and Prod VLAN for the pc.radius-s...
yes, both of them are solved.The other changes from my mine, voice vlan remains to be hard code on the Phone.(I don't want to rely on the LLDP/CDP between the phone and the switch at this moment) and all the other device vlan will be handled by the w...
Dear All,I have resolved the issueAbout the domain (Voice/ Data) I adjust the vendor-specific on the Windows NPS server. it sends the correct domain to the switch after authenticationAfter upgrading the firmware, I have successful with the below sett...
I have change the authentication host mode to multi-authif running, if I put the PC connected to the phone, the authentication method for the phone will auto-swag from mab to dot1x... and drop the PC... I also remove the authentication order and auth...
I just figured out the issue, if I put the phone only, it will not have any authentication process...but the port will remain something connected already.. (even mac address table)I also try to enable LLDP globally to see if the phone will have respo...
