Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have an old Catalyst 4948 and I'm testing the ports on it and am a little confused. Can I use the last four ports on the face-plate (Gi1/45 - Gi1/48)? Whenever I plug in an Ethernet cable into the last four ports, there isn't a light indicat...
Hello,I started to configure a Cisco 6513 but I'm not sure on where to go from here. The goal is to test the ports on the blades. In this case I have multiple blades but right I'm just using one to make things more simple; eventually I'd like to be a...
Hello,I booted up a Cisco 2690XR-24PS switch and got this message. I tried looking online to see what the message is and all I can was this (see link). What is this message and is this something I should be worried about? Should I update the IOS just...
Hello, I have a few question about RDP on a Cisco 2851 router. I have a Cisco 2960 switch hooked up to the router and two computer going into that switch. I can RDP into computer 172.16.1.3 but I have to do it through the router ip address (172.16.0....
Hello, I'm pretty new to networking. My boss would like me to physically test the ports on 24/48 port Cisco switches ranging from 2960X, 3560X, 3750X, etc. Is there a way to physically test all the ports simultaneously without having to do it one by ...
Thank you, that worked! Thanks for clarifying a bit, I would have never guessed the ports needed to be enabled for RJ45. I'm a newbie so at first I thought those ports were bad until I tested another 4948 and had the same situation. Thank you everyon...
I changed it to 0x2102 and reloaded but it booted to Rommon mode so I had to change it to 0x2101. Would that make a difference? Also, I tried again with ports Gi1/45 - Gi1/48 and there's no light indicator. You say as per the device information, it i...
Hi Scott,Which port is the default route out of the 6513, is it port gi7/3? A few weeks ago I was able to configure a Cisco 2851 router and had another small test lab going. The 2851 had a g0/0 and g0/1 port which I could configure and the lab worked...
Hi Scott,I had to change vlan1 IP to 172.16.1.99 and my lab computer is 172.16.1.100 with a default gateway of 172.16.1.99. I configured port g7/3 to be 172.16.0.99 and on the Sup I'm able to ping vlan1, lab computer and the FW (172.16.0.1) but still...
