Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team Cisco and everybody.I want to order License part: LIC-UCM-11X-ENHP-ABut this part already End of Sale and I can't find the replacement part.Please tell me if you know replacement part,If it's not have yet replacement part, when it have the re...
Hi Guys,Please help me this case.I have old AIR-CT2504-K9 in use and new C9800 Controller.I want to migrate all config from CT2504 to C9800, include Mac Address Allow on Access List Is there any software or a way to help me?Thank you guys.
Hi guy,I am searching for ISR4000 Series ( ISR4321/K9 ) does it support GLBP ( Gateway Load Balancing Protocol ) feature? And does it need license to use?I searched many websites and found no information.Please help me to findout.Thank alot!
Hi everyone,I have a question, does the AIR-AP1832I-S-K9 support mode standalone?I saw " Standalone " in deployments Mode, but in the software I can't find to download autonomous mode ( Only Lightweight and Mobility Express ).Please explain for me. T...
Hi Guys, I need your help.I have a Controller AIR-CT5520-K9 Does not work with module GLC-LH-SMD=. Two side with same GLC-LH-SMD=.Only one port SFP used.Please troubleshoot this problem
In this link say yes, 5520 support SFP-H10-CU3M https://www.cisco.com/c/en/us/td/docs/wireless/controller/5500/5520/install-guide/b-wlc-ig-5520/m-overview.html
Hi Mr Leo Laohoo, They plug GLC-TE in port 1, GLC-LH-SMD in port 2 and restart the controller. After boot up, the led 10Gb bright, but status in two ports is " link down " Port 2: GLC-LH-SMD have line in from switchPort 1: GLC-TE No line in, just plu...
Hi Mr RRudling,Yes, We knew GLC-LH-SMD is 1G SFP. But I dont know why when my customer installed GLC-LH-SMD=, the controller still power up led 10G. but no led in the port 1 and port 2. In WebUI, status of two ports is " link down "
