Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to automate the removal of Fireamp via the command line and its not working. If I run the command and enter the password it works. If I run it silently it doesn't. Any Ideas? Im using the command line example below for this example Ive...
We have some offices connected via an ASA Site to Site IPSEC VPN to our HQ which houses a CUCM. The Internet line experiences just under 1% packet loss per 24 hour period. However this sometimes causes the site to site VPN to drop and reconnect abou...
Hi Folks,I have currently setup an ASA at a remote site in the middle of the USA which tunnels all traffic back to our West coast HQ to use its Internet connection. It works great. However, I also want to have another tunnel to our East Coast HQ to...
I will reach out to Dan privately to share something regarding a Cisco device that carriers use, the Cisco IAD 2400, has a role here after getting up to the carrier's engineering department.
Its all one vender, Cisco CUCM, Cisco voice router with MGC...
I was the one who submitted the SR.
I emailed COX Communications engineering department to see if they are the only US carrier who makes NULL appear as ASCII but in the past they said they pass whatever is sent to them and either another US carrier...
After a few weeks of troubleshooting after applying this with TAC and our Carrier it turns out that some companies use old PBX systems that deliver their caller id as <NULL>. This is fine if a customer is using H.323 or SIP because you can convert t...
I bricked two 5596-UP's last night thanks to this bug. Why isn't there something in the upgrade documentation stating you must have a specific hardware version 1.1 before upgrading? When it goes through the pre-upgrade checks why doesn't it check th...
We also turned on this feature to help with a ASA transparent firewall we are sticking between our 2 N7K VDCs. %VPC-2-L3_VPC_UNEQUAL_WEIGHT: Unequal weight routing is not supported in L3 over vPC. Please make sure both vPC peers have equal link cos...
