Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Guys, hope you can help...I've got a /23 LAN subnet which i need to route out to a carrier in different ways...192.168.0.0/23 is the LAN Subnet but when it comes in on the HSRP active i need to tell that active router that if the traffic is from the ...
Question; simple setup two routers back to back...Using an inbound ACL to determine packet count on one side, send 1000 icmp packets from the other side through the ACL and the ACL shows 3000 matches!No fragmentation....Anyone have any ideas?
Hi Guys,Strange one, i have configured a secondary subnet on a dot1q subinterface to allow for expansion. I created a secondary ip address on both interfaces, then configured another standby group for this subnet, something like this:R1:interface Gig...
Guys, i've read about the upgrade path from 4 to 8 but in my situation the hardware isn't coming with... We want to move from a stand alone version 4 platform to a virtualized version 8 platform. We were going to build the new platform as a new clust...
Sorry, probably a noob question here...I'm setting g711 in my region config for calls within the same site but when i initiate a call and check the call stats it always shows g722, can anyone tell me why? If i set it to g729 thats shows up fine in th...
Hi Karl,This was a while ago now and we didn't actually end up doing it that way. We built up a brand new version 7 cluster and just ran an ICT between the two systems.Hope you're migration goes/has gone well.Rich
Ok, so i think what i'm going to do (for CUCM) is:Take the PUB running version 4 and pull one of it's drives.Step Upgrade this PUB to 6 then to 8 which i know is unsupported.Get the license file from the new version 8 PUB.Roll back the PUB to version...
Sorry, thought you used DMA to get from windows based to linux based, not between 6 and 7 etc?Yeah i think new cluster is the way forward as it will let us do this in a staged approach, the CUCM deployment is pretty simple so BAT should be ok but we ...
