Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I'm testing SR-TE using PFP on a lab enviroment and I have a doubt on my configuration. I have a CPE connected to a Cisco ASR9902 that is the Head End of the SR-TE, the remote tail end is a Cisco ASR9000. Sending traffic from the CPE to remote...
Hi in our LAB we successfully upgrade our Fabric ACI to 5.2(7g) version after a complete cleanup of APIC and switches I expected that the Cisco APIC creates the following default interface policies automatically:
CDP (cdpIfPol)system-cdp-disabledsyst...
Hi, we have a Cisco ACI in our LAB enviroment with an older version 2.2. We'd like reset/clean all the fabric (n.3 APIC,n.2 Leaf and n.2 Spine) and restart with a new version, the 5.2. Our hardware support it
We don't need the backup of actual config...
Hi
I'm working with a Cisco 819 4G/LTE (model C819HG-4G-G-K9) with modem Sierra MC7710
When the router attached to the UMTS mobile radio network I saw that the speed is 384000bit/s as showed below:
Cisco-819#sh run | beg line 3
line 3
script dialer...
HelloI need an EEM applet that every 60 sec execute a show command and then write the output of the command on the flash memory of the router The output of the file might be not override because I need all the output of the show captured every 60 se...
Hi I solved, I have to put color 100 at the remote BGP VPNv4 prefix , in this way the traffic towards that prefix switch over SR-TE with color 100 and depending on the FC value the path will follow SR -TE policy path with color 60 if traffic source i...
Hi, I'm continuing with the same thread without opening a new one as it is the same ACI fabric as the post
We have updated successfully the 3 APIC controllers at 5.2 and would like to update the Leaf and Spine switches but a doubt has arisen after re...
Hi Robert
thank you for the answer
Our switch support 5.2(2) we check here
https://www.cisco.com/c/dam/en/us/td/docs/Website/datacenter/acihwsupport/index.html
Our CIMC firmware is old , version 2.0(9c)
But it seems is supported. Our idea is anyway ...
Hi, same issue using ASR1001-X with asr1001x-universalk9.03.16.00.S.155-3.S-ext.SPA.bin
Solved after inserting/removing a 10G SFP tranceiver into the TenGiga port
All of those messages above disappeared and never happen again
*Jan 12 06:08:08.622: ...
