About urbinir

urbinir · 06-07-2024

Hi in our LAB we successfully upgrade our Fabric ACI to 5.2(7g) version after a complete cleanup of APIC and switches I expected that the Cisco APIC creates the following default interface policies automatically: CDP (cdpIfPol)system-cdp-disabledsyst...

urbinir · 04-19-2024

Hi, we have a Cisco ACI in our LAB enviroment with an older version 2.2. We'd like reset/clean all the fabric (n.3 APIC,n.2 Leaf and n.2 Spine) and restart with a new version, the 5.2. Our hardware support it We don't need the backup of actual config...

urbinir · 05-19-2016

Hi I'm working with a Cisco 819 4G/LTE (model C819HG-4G-G-K9) with modem Sierra MC7710 When the router attached to the UMTS mobile radio network I saw that the speed is 384000bit/s as showed below: Cisco-819#sh run | beg line 3 line 3 script dialer...

urbinir · 02-10-2013

HelloI need an EEM applet that every 60 sec execute a show command and then write the output of the command on the flash memory of the router The output of the file might be not override because I need all the output of the show captured every 60 se...

urbinir · 09-29-2012

Hi,in the Cisco 7600 we have the following command to configure a service instance:service instance id ethernet [service-name]Searching information for the meaning of the service-name option I didn't find nothing..Do you know what service-name do an...

urbinir · 05-27-2024

Hi RedNectar thank you, So we follow your suggestion and Leaf&Spine switch upgrade was successfully done! Thks again

urbinir · 05-19-2024

Hi, I'm continuing with the same thread without opening a new one as it is the same ACI fabric as the post We have updated successfully the 3 APIC controllers at 5.2 and would like to update the Leaf and Spine switches but a doubt has arisen after re...

urbinir · 04-19-2024

Hi Robert thank you for the answer Our switch support 5.2(2) we check here https://www.cisco.com/c/dam/en/us/td/docs/Website/datacenter/acihwsupport/index.html Our CIMC firmware is old , version 2.0(9c) But it seems is supported. Our idea is anyway ...

urbinir · 12-13-2016

Hi, same issue using ASR1001-X with asr1001x-universalk9.03.16.00.S.155-3.S-ext.SPA.bin Solved after inserting/removing a 10G SFP tranceiver into the TenGiga port All of those messages above disappeared and never happen again *Jan 12 06:08:08.622: ...

urbinir · 05-19-2016

Hi mchance, I'm not sure of that because if I switch on GSM/EDGE mobile network that output showed the tx and rx speed in different and separate values..instead when attached to UMTS network the output showed a value only as explained above Cisco-8...

Member Since	‎07-01-2002 05:45 AM
Date Last Visited	‎06-11-2024 01:03 AM
Posts	32
Total Helpful Votes Received	5

User Statistics

User Activity

ACI Default Interface Policies doesn't appear

Rebuild Cisco ACI with a new version

Cisco 819 speed values

EEM redirect without overwrite the file

service-name meaning in the service instance command

Re: Rebuild Cisco ACI with a new version

Re: Rebuild Cisco ACI with a new version

Re: Rebuild Cisco ACI with a new version

Hi, same issue using ASR1001

Hi mchance,