Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey everyone, I'm trying to configure SNMPv3 on a switch to send specific traps to a SNMP manager in this case Solarwinds. I need to collect the following information:CPU, energywise info, interface status (up, down), temp, trending for related data,...
Here is the SNMP configuration I need to make sense of. 1) mac address-table notification change interval 02) mac address-table notification change3) snmp-server enable traps mac-notification change move threshold4) snmp-server queue-length 305) snmp...
According to the Cisco Cyber Vision datasheet only the Cisco IC3000 industrial compute switch that is cyber vision compatible.....However that switch only has 4 ports so you would need to purchase quite a few to plug in all the end devices. In compar...
Appreciate that feedback, while I have you I had an additional question. Would it be security best practices to implement FTD rather ASA to take advantage of NGIPS? Are there any other features that are gained when running FTD over ASA ios? Other tha...
@Vinod Arya wrote:I dont think there is a way to control Traps per interface wise. For sending specific traps to a perticular snmp-server we can use trap names after the host command : snmp-server host snmp-server host x.x.x.x public bgp .. .. . -Th...
I don't have an answer for you other then I'm having the same problem, there isn't any good documentation on SNMPv3 configuration with users, groups, and views and best practices for configuring that. (that I can find) Kind of frustrating.@Yermander ...
@Massimo Baschieri wrote:I have no experience with it and maybe I'm wrong, but ICS3000 is not meant as a host serving switch, instead is used as an IDS sensor by cybervision, you have to place only few of them in order to monitor the critical nodes o...
