Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How to write the certificate which can be use by two FTD (HA pair)?
After I set up the anyconnect setting on FMC VPN(remote access), PC can now successfully access the FTD's Outside interface and get the IP addrsee from IP pool. But it keeps show...
Hi Team, I successfully integrated my ISE (ver 3.0.0.458) and Stealthwatch (ver 7.3.0) with pxgrid, also I can see the 802.1x clients live session on ISE (ip addr 10.40.5.81). And local DNS server works well on stealthwatch ,because stealthwatch's F...
After I integrated ISE & Stealthwatch . I can't see any users on Stealthwatch>Monitor>USERS ,also I can't apply ANC to the host.I follow the guidance on this posthttps://community.cisco.com/t5/security-documents/deploying-cisco-stealthwatch-7-x-with-...
Hi all,I'm trying to ssh from the cisco 2960 to the Aluomniswitch 6860,but it keeps failing.Below is the error messages. SpoilerSSH0: starting SSH control processSSH0: sent protocol version id SSH-1.99-Cisco-1.25SSH0: protocol version id is - SSH-2.0...
Hi hslai,
I found it on Cisco Software download ,but it's said that AnyConnect version 4.10 support only ISE 3.1 and later .
But the problem is 3.0.0.458 is the highest version that can be install on our cisco SNS 3500 series server. I can't even fi...
Hi @Aref Alsouqi ,
Here is the guide I follow https://www.cisco.com/c/en/us/support/docs/security/firepower-ngfw/213905-configure-anyconnect-vpn-on-ftd-using-ci.html
I think maybe I should name both FTD in same hostname,so that they'll only have ...
