Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone I have been researching the forums and some models come to mind. Basically i am after a CISCO router that will happily handle a 350Mbps internet circuit.- Will have about 30 NAT and PAT rules- 5 vlans- 50 users. - slash 29 wan subnetRegar...
Hi Everyone
Hardware wise, I manage a CISCO 5508 and a 8540 wireless lan controllers, so am familiar around the GUI.
With the release of the VMWare Cisco WLC, this is ideal for a lab environment for development and testing. However anyone who has u...
Hi EveryoneI have an unusual one here, our iphone users can connect to SSID but on first connect don't get internet access, if they disconnect and then reconnect the connection is fine. So on first connection they do get an IP address, other devices ...
Hi Everyone I am after the ability to factory default AIR-LAP1142N-E-K9 access points remotely. I have access via SSH and have access to exec. BUT, I have searched the forums and CISCO documentation and the commands recommended don't exist on these a...
Thanks for the tech note, i had come across that before and wondered how believable those figures were. We have to read them with CISCO being cautious and with all features of the router enabled.I have a 1921 at the moment in the lab and quite often ...
Hi ScottThe access points (about 10 of them around the country) are on the network and "joined" to the 5508 WLC. However these access points, while they do connect to the WLC, immediately disconnect, meaning I can't reset them from the WLC.I also don...
