Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have recently configured one of the spoke routers in Azure. The configuration is identical to that of other locations spoke router. Each spoke has three hub routers under a single NHS cluster. The traffic between the on-prem hub and the cloud-spoke...
As far as I have understand the newer 17.18.2 software version on 9800 wlc It is possible to configure the 9167E as URWB. So I have the following questions:When i want to use on a single 9167E AP simultaneously as URWB and for WiFi for the clients do...
We have been running DMVPN across all our branches and Headquarters. There are three hub locations under two different WAN connections, and each spoke is connected to those three hubs via NHS clusters. Now, two hub locations also have Site-2-Site VPN...
We have one single Cisco 9800 WLC on productive. We want to add another 9800 WLC to create SSO. I didn't find any proper document outlining the steps to follow. It would be helpful if someone shared who has experience configuring WLC SSO in such a sc...
There was an issue with uploading the new image to the backup FMC. To find out why I want to access the FMC via cli and find the password wrong. So, I have checked the document to reset the password. After rebooting the host with single mode, try to ...
Hey, thanks a lot for your help. The links you have shared have answered almost all my queries I just have one question about mobility. Should an AP connected to wired be configured as based and the AP mounted on a movable vehicle be configured as a ...
The model we're using is the C9800-L-F-K9.Together, 22 APs are joined to the running WLC, which is the active one. In the next two years, another 40 APs will join.The peak of daily wireless clients is 280.Yes, external web authentication is configure...
Thanks Marius for your time. Unfortunately I have experience the same issue when I type the command "sudo usertool.pl -p ' <new password>'. The output shows "module is unknown".After contact with our partner company, the TAC engineer suggested updati...
Hello Marvin, thanks for your message. The next day I have synced the Snort rules and the update is done without any further issue. You always give a great solution regarding Firepower issue. Three cheers to you!
