Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hilooking for a solution to use DHCP as a central service in MPLS VPN. DHCP server needs to be able to support overlapping IP ranges.Option82/VPN ID - what DHCP server supports this solution?Jon
Hiin order to configure peering between 16bit ASN and 32bit ASN - what is the requrement?Would this be the correct configuration?router bgp 45678neighbor 1xx.0.0.2 remote-as 3.3What software supports this configuration? (for C7600, RSP720)According t...
HiWe are facing problems with etherchannel on 7609/RSP720/SRCEtherchannel between ports on X6724 cards OK. We have 2 portchannels running on this cardEtherchannel2 with member port 5/1 and 6/1 are not working stable. Configuration OK, some traffic co...
Did you consider MUX-UNI to avoid xconnect on Vlan interface::interface TenGigEthernet 7/1switchportswitchport trunk allowed vlan 75sw mo trunkinterface TenGigEthernet 7/1.100encap dot 100xconnect x.x.x.x .....
Change to port-based on PE like this:7609-PEint gig 0/1xconnect 10.2.0.5 2500 encap mpls12406-PEint gig 2/1/0xconnect 10.1.0.8 2500 encap mplsWhen connecting MST regions to PVST+ or RapidSTP make sure root of vlan is IN MST region.Better is lower, co...
We have been using LDP/Etherchannels for ages without problems(Layer 2 etherchannel, LDP configured on interface Vlan)7609/SUP720, 7609/RSP720IOS started at SXD, gone through SRA,SRB,SRC, currently at SRE3jon
Check notes below this paragraph:Power may run in 2 modes: 2700W or 4000WConnecting 2 DC connections provides 2700WConnecting 3 DC connections provides 4000WSelection is auto-sensehttp://www.cisco.com/en/US/docs/routers/7600/Hardware/Chassis_Installa...
