Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks,
I'm testing to deploy a 2811 router to connect a standard phone line (as provided by the local cable company) and use it as my voice gateway for my 7940's, on 16 Fast Ethernet ports on the router (NM-ESW-16). I've got a VIC2-FXS 2 port car...
Hi Folks,
I have a situation where one of my remote locations on a PRI is experiencing very poor call quality. It's not all the time but it is an issue. I'm running a 2811 with an AIM module and 7912/7940/7960's - about 10 of them at best. I've c...
Hi Folks,
i have a strange problem whereby my dchp scope exclusions do not seem to be taking effect... as you can see I have defined my excluded address ranges but the pools show 254 addresses. Why?
no ip dhcp use vrf connected
ip dhcp excluded-ad...
Hi Folks,So I'm running a 2851ISR with 12.4(15)T14/CME4.1(0)/CUE 7.0.6 I've changed all references to a MOH file (OnHold1 to OnHold2). I've made this change under the System Parameters, in the Service Engine, and Telephony Service. Then I deleted ...
Hi Folks,Hope I'm posting in the right section...I have a 2811 router that I want to configure the F/E 0/0 & 0/1 to be able to communicate.FE 0/0 is configured with 192.168.16.1/24FE 0/1 is configured with 10.10.10.10/24 Physically attached to th...
Hi and thanks for jumping in...unless I'm doing something wrong I can't issue a sh ehpone moh command. I get an invalid input at the moh. I did reboot the router without success and from what I've narrowed down, the offending moh file is only being ...
Appologies for the delayed reply but being the one man band of the IT department has a tendency to spread me a little thin sometimes.I changed the default gateway on the wireless router, keeping the connection through a LAN port, and was able to ping...
Rick,Thanks for chiming in here. I created access-list 1 in my attempt to resolve my issue. I based it off of an access-list configured on a 2851 that I have at my location. I've completely removed access-lists 1 and 110, removed the nat and acces...
