Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Sirs.
My brand new SF500-48P switch seems to have problems while operating with PoE enabled. When I try to enable power on port #1, for example, the power is enabled on port #2, and so on. I tried resetting the device to factory defaults, as wel...
Dear Sirs.My customer plans to extend existing wireless coverage and upgrade to controller based network.Let me shortly describe the situation based on the attached network map.RAP points are installed on the buildings, they have wired uplink.MAP poi...
Dear all.My customer returned me a malfunctioning Cisco 1242AG access point. In the end of initialization process I see all three LEDs are solid red. I revealed that this due to the corrupted IOS image. I reflashed the AP via TFTP server to firmware ...
Dear Sirs.I have to deploy 6 access points in a warehouse. I want one of them (which will serve less clients) to act as WDS access point. I've configured local RADIUS server on this AP (WPA + TKIP). I've also configured WDS service on this AP, config...
Kindly advise what part number of 1300 Series bridge should I order to have maximum 100 mW power output in .11b mode. I intend to use external antennas.
Dear Sergey.
I've performed a thorough testing of the unit. The half of ports works OK (ports 1-12, 25-36).
I've observed that the mapping of power is incorrect on the second half of ports (13-24, 37-48).
I attach a table with the description of issu...
Scott, can I setup a MAP to connect to a particular RAP? For example, referring to my network map, I want MAP11 to connect directly to RAP4 using directinal antenna and not to MAP8. Can this links be manually configured?KRAlexei
Hi Scott.Thanks for the prompt reply.The access points which need to be upgraded to LWAPP mode are 1242AG points, they do not support 11n, so I think I can use that upgrade tool. The thing is that points (MAP1, MAP2 and MAP3) are already mounted on t...
