Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyoneAs soon as I have my device in maintenance mode, I can't get it out of this mode,I get the warning message as soon as I activate the Scheduler Maintentance. please,what does this look like for you?
HelloI am struggling a bit with BGP and different IP Subnets. Well, I can now reach the two directly attachedneighbors AS100 | 10.10.10.7>-<9.9.9.8 | AS200 But why arnt possible to reach the L0 interfaces?yes remote-as and the Net, i have created. th...
Configuring c1921 with a couple SVI interfaces, yes the Switch neighbor willrecieve the IP defined from the scope that i give, and ping alive both side.VTP v2 Server setup c1921, and Switch running Client mode butno VTP synchronisation will be succee...
HelloI have now completed the SDA/DNA > Catalyst Center course and I am glad that I can now look a littledeeper into the subject.But I still have two burning questions that interest me and therefore I would like to take this opportunity hereyes, now ...
Dear members, please i need your helpi have installed today the 17.12.1 Image on me 9120AX EWC (i dont have anypossibilities to create for this any tac, this AP was a private ebay investigation)after the installation the AP did not come up anymore, l...
Hello balaji.bandi and VIP MHM Cisco Worldfirst let me thanks for your quick Answer!i have 2 Site A and BSite A Ethernet0/0 10.10.10.7 UP UP>L0 7.7.7.7Site B Ethernet0/0 9.9.9.8 UP UP>L0 8.8.8.8Also on sh ip bgp summ, i see the Loopback interface IP ...
yes this Switch and Router has a trunk connection betweenand are connected together.Switch!int gi1/0/48Desc ** Trunk to c1921 **switchport trunk allowed vlan 10,20,30,40,800switchport mode trunkend!Port!int range gi1/0/1 - 10description client and vo...
meny thanks Marce1000, and Leo Laohoo for your Help, yes the AP booting correctly now did the Booting-patch update my BIOS/firmware right away?and I'm just wondering how to proceed, about selecting the correct IOS, I use the 9120 as an EWC,which one...
Hello @Flavio Miranda Thanks for your quick answer, the syntax "install add file flash:cat9k_iosxe.17.06.05.SPA.bin activate commit prompt-level none"with the syntax "prompt-level none" no answer will be need and auto-reboot without any input are nee...
