Short Version - I need to know if there is a way to modify the dialer script or some other Cell/Line parameter to force a second gen 4G EHWIC-4G-LTE-V to use Band 4 vs Band 13.
Details - I have 15 or so sites configured with HWIC EHWIC-4G-LTE-V 4G c...
Quick question Is there a way to disable the Slot 1 interface from failover? Specifically I have an ASA Active Standby config with AIP-10's in Slot 1. I would like to keep the failover config but not monitor slot 1. Thanks,
Got a strange one.When setting up an IPSec RA Profile the IP Pool assigned does not take. Running 8.4.1 on a 5540.If I set the authenticaiton method to local the IP Pool is assigned and all is well. If I then go in and set it to AAA and use my Safew...
Is there a way to log the violations of a MAC ACL on the current IOS of the 2960-3560 family?If not is there a way to just to allow DHCP and restrict all other L2 Traffic by using a MAC ACL?
I am having trouble getting PBR to work with a VRV interface. I have a 3560 L3 Switch running an IPBase image. The SDM template is Desktop-Routing.The target is to get the 10.1.10.0/24 host to route to the FW-B firewall. Default route on the L3 sw...
Blocking port access via a MAC address ACL. Would like to know when violations occur against the ACL. You can get this with portsec but due to the roaming of hosts portsec is too administrative intensive. 802.1x is out too as the sites are remote...
Yes I am aware of that but there are ways to restrict specific protocals and I was hoping someone would have found a way to log against a mac acl. Ether this has not been done or not many are using this feature.Ken...
Dave,Funny as these units are racked one on top of the other. I also have a redundant pair of 525 which we use for our lab envionment which are configured with the same hardware and IOS. The config differes only with number of interfaces in use and...
