Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We wanted to hide a small network of voip phone behind one valid pstn#. Big issue I don't know, is what happens when someone calls in. How do I - make all hpones ring or give the choice to one phone or another?? 1751.. I can run CME / CM3.0.. U...
I have a VOIP network that I want to setup. But with no POTS at this time. I have a Callmanager3.0(8) -1751 head end to adsl. Remote sites are 806'es. Using ata-186'es. The dial-plan - do I need a dialplan at both the 1700 and 806 to point at each o...
Hello,Found that CDR can be read by CAR from you all. I have CCM 3.0 (8) running. Can't find download site on CCO. Can someone point me in the right direction.Or show the SQL way to do things. I haven't got the hole database thing down yet.ThanksPhil
Hello,I have a site to site. Static / dymanic. Have to get from static to dynamic. Was told about dynamic DNS software. Will tihs work with out a server behind the 806. I want to term my IPSEC Tunnel on to the router. Can it be done with config's. Wh...
Hello all,I find my self with two ata-186's that I would like to use from one ip network -- through the internet --- to the other ip network. Ca. to Hi. thought it be fun to set up. Can this be done WITHOUT Callmanager or a Gateway server. Can it be ...
We ran into this cisco bug: CSCef20529It's not the 3600. But it sounds the same! We could have the provider loop the B channel but we could never ping anything!! Even a loop back to the routers interface, it could not see!! This was the command that ...
Sounds like a wireless issue.. Check the ap signal. And is the phones able to talk from 1mb to 11mb if 802.11b! If the phones can talk at different rates. That that could be it. Meaning, if you move out of the 11mb area then the phone will not move d...
sounds like you have the ata-186 in default mode! It runs a codec of g711. RxCodec and TxCodec—Configure the codec ID.G.723.1—Codec ID 0G.711a—Codec ID 1G.711u—codec ID 2G.729a—codec ID 3Satellite will give you delay!! Try to find a way to use QoS in...
You will need to look up the supported hardware. CCM 3.0 works on Compaq dl320 , dl380's (other ibm platforms to). This is the best way if you plan to use the callmanager install disks, wich loads a small ver of WIN 2K Server. This will not work as i...
