Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,Thanks for reading.I'm having trouble with routing remote clients to talk to each other. Also having trouble seeing the IPSEC SA consistently stand up. No passwords configured. Thanks for taking a look!Bob
Hi there,Thanks for reading!I ran a capture on a C9200 with these parameters and only captured one-way traffic. I was trying to see if the server at the destination IP was responding and thought that 3rd line Direction: Both would reveal the traffic...
Hi there,Thanks for reading!I'm seeing an oddity when trying to join a laptop to an SSID in PT. The problem is in the UI where I set configuration for Wireless0 nic. When I select an authentication type, the cursor jumps to the WEP password field a...
Hi there,Thanks for readingI'm trying to set up a PRIV SNMPv3 config on a C9200 running 17.6.3 to allow connection to our Solarwinds server. Debugging leads with an "Unknown Engine ID" error. I'm able to see the local engine ID but suspect that I n...
Hi there,Thanks for reading.I recovered a c9200l running 16.09.04. I write erased successfully. Verified the switch stack consisted of 1 single member (itself). I then ran install add file usbflash0:cat9k_lite_iosxe.17.06.03.SPA.bin activate commi...
Thanks for pointing out the samples. Seems there's a LOT to choose from. For clarity, I was trying to configure 802.1x but the cursor would jump to WEP password. Pretty sure I was running into a bug. Moving on... thanks again!
Thanks! That page had this one embedded: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/snmp/configuration/xe-3e/snmp-xe-3e-book/nm-snmp-snmpv3-comm-supp.html which had this command (which configs the engID for remote user):Example:Device(config)...
