Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to manage a Catalyst 2960 switch with Ansible. The ansible controller is installed on a Linux VM. I haven't been able to SSH to the switch from the controller despite the service being enabled on the switch and the controller. Connection...
I have been trying to SSH to the DNAC using the maglev user for troubleshooting purposes. I can login to the webui just fine. However, SSH won't work. I tried creating another admin user on DNAC, same issue. Are there any other DNAC setting required ...
In the Cisco WLC DHCP configurations doc, it states that requiring DHCP Addr. Assignment is best practice for security. How can it possibly enhance security when DHCP itself is considered not very secure?
I have been receiving these error messages while I'm trying to join a LWAP to the WLC. I tried running the command config ap cert-expiry-ignore mic enable on the WLC, but it won't work.WLC software version is 7.6.100.0.AP model AIR-CAP3502I-E-K9AP im...
I have configured the WLC with management IP which is in the same VLAN as the switch port. However, the port would not come up on the switch and I am unable to access the WLC gui. I am unable to ping between the WLC and the switch or the PC. I am not...
I tried that, but still unable to ping. I setup a static IP connection for the ethernet interface on Linux. Before that, the ethernet would just not connect at all
I added another Bridged adapter with PC attached to F0/1, no luck. I also set a static IP on the Linux VM for the other adapter to be in the same subnet, but still unable to ping the switch.I'm not sure if the adapter type matters because from what I...
