Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Nexus 93180YC running 7.0(3)I4(2). That we need to upgrade notwithstanding, I think what we experienced is a misunderstanding of our understanding of the auto-recovery concept. We had a hardware failure of the primary vPC switch. It was a vPC peer...
On Nexus 6001s, running two different NX-OS versions (6.0(2)N2(5), 7.0(8)N1(1)). show lacp neighbor output looks inconsistent. Partner Flags says neighbor is sending fast LACP PDUs, but Partner Port State says 0x3d, which decodes to slow LACP PDUs....
I'm having an issue with an interface incrementing giants, when I don't think it should. The setup is a Catalyst 6807 connected to a Catalyst 9500-X. The 6807 is the one incrementing giants. There are no input or CRC errors. 68079500interface TenG...
I work in a large enterprise. We run our own MPLS environment for macrosegmentation. See attached diagram.We are converting from EIGRP to OSPFv2 at our remote sites. Remote sites are running their own single-area OSPF instances (no area 0). We ha...
We are having some issues with MPLS stability in our metro Ethernet environment (LDP fails; OSPF does not). We're going to turn on BFD. We have multiple remote sites using OSPF peered to 3 or 4 hub routers on a /24. I've done a lot of reading, a l...
So, how do the maintenance releases work?The way the blog is written, it sounds like there's going to be a 26.1.1 and a 26.2.1, and that's it, until 27.1.1, 27.2.1, etc.But the illustration of the numbering indicates there will be maintenance release...
Hi Balaji,I appreciate the reply. However, I'm the network engineer; I don't have access to the NetApp or its configuration. All I can tell you about the NetApp is the CDP data, which says AFF-A700, port e10a, and NetApp version 9.5P16.I appreciate...
Hi Tehransoccer,Did you ever get a resolution to this?We've got some Oracle equipment connected to a vPC pair of Nexus 6001 switches, running old software (NX-OS 6.0(2)N2(5)). One of them experienced a hardware failure. We had some Oracle interface...
Hi Reza,This is a production device, so I can't change the MTU to experiment.The 9500 is an MPLS PE; the 6807 is an MPLS P. We set the MPLS uplinks to MTU maximum for the platform as a general practice. We don't have more than two labels in the sta...
Thank you. Got another reply with the same information.Now the question is, what to do about it. With EIGRP, redistributing the default route from VPNv4 into EIGRP allowed both PEs to use each other's default routes in the event there was an iBGP s...
