Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi everyone this topic is been posted few time and there were some solutions but its not working. Below are the logs from a access layer switch(c3650) which blocks the trunk port. this switch is connected to a layer 3 switch(c3850) in that switch its...
hi
i have a WS-C3850-48XS with ipservices license and SW version 3.07.04E and a WS-C3850-12XS ipbase license and SW version 16.6.2. I am planning to stack these two with 48xs has switch 1 and 12xs as switch 2 and also upgrade the 48XS to 16.6.2....
hi
i am facing this weird problem. i created several VLANs from my distribution switch and it is propagating to all of them except one switch. the configs are the same but not sure where the issue lies. Can you please give me directions on what to l...
hi
need help in setting up stack config for 3850. i have 2 switches of the same model one should be the master and other should be the member. i have a stack cable and i have another cable not sure what it is for you can see the in the picture i h...
the version number in the VTP status was a mismatch. so i toggled the VTP mode from client to transparent and back to client which the matched the version number same as the distribution switch and the problem got fixed. Thanks for your input
the version number in the VTP status was a mismatch. so i toggled the VTP mode from client to transparent and back to client which the matched the version number same as the distribution switch and the problem got fixed. Thanks for your input
