Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloRecently I've been looking into posibilities for extending a DMVPN (already implemented) with very small (1-2 user) remote locations over a single ISP link.I would like to use what is basically the smallest Cisco router that supports DMVPN and E...
HelloI am trying to setup a GETVPN network. The idea is to encrypt all GRE traffic between peers (for DMVPN use). Also, there can be no dedicated KSs (no extra routers that can handle this).The VPN is brought up successfully with only one KS. However...
I'm currently using LMS 3.2 and would like to integrate it via TACACS+ with an ACS 4.2.I hope this is the right place to ask my question.I encountered a problem while configuring AAA mode in LMS: after setting "AAA Mode Setup" to ACS (instead of non-...
I am having trouble with the password recovery procedure on a CiscoWorks 3.2 installation. The problem is that I've no idea what software versions are running (never kept track).I tried following the steps here: http://www.cisco.com/en/US/products/sw...
Anyone escalate this to support?
Anyone TEST this?
It's obvious why the TMGMatrix says "NO" - the module cannot work at 25gbps for obvious reasons. The question is is "will it work and be supported at 10gbps speeds"? It also stems from the fact that ...
Problem solved. Long live google search on Cisco.com.There are several workarounds:- Move the DHCP server function to another device like a WLC or a router.- Downgrade the ASA to 9.1.1 or lower. - Moving the device to the wired network seems to not t...
You're on a wrong track.As you can see from the (full) output, the "order of messages" isStep 1: Client -> ASA = DHCPDISCOVERStep 2: ASA -> Client = DHCPOFFERStep 3: Client -> ASA = DHCPREQUESTStep 4: ASA > Client = *For a working client, Step 4 resu...
