Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all.I've added a new B200M3 to my chassis and created a clone of one of my existing B200M3 profiles and I'm getting the following error. I've never seen this before and attached a picture
Tried going from 6.0.0.1 to 6.0.1 and now get this when I login:
The upgrade failed to install.The upgrade failed to install.
The upgrade failed on while running .Please contact customer support:
tac@cisco.com1-800-553-2447 or 1-408-526-7209
When...
Hey all, I was able to pick up a almost brand new UCS B series starter kit. It includes (1) 5108 (6508 model) chassis, (2) B200-M2, (2) UCS-6248UP's and (2) UCS 2208XP.
My question is can I convert this to a UCS Mini aka can I swap the 2208XP's with ...
I'm having trouble with desktop phone control. I did a wireshark trace and its doing a SIP register with my old mac SEPXXXX.I swapped phones by changing the MAC address field in CUCM and re-associated it under end user.Any ideas?Thanks,Mike
Hi All,I can't for the life of me figure out why I can't upload a prompt on version 8. I thought it was a permissions issue so I made my user an admin and that didn't work. So then I login via crsadmin and it still won't upload.I get authenticated v...
Marvin,
Thanks for the reply. I found the log and also found out the power was cut during the upgrade....not good.
[170307 22:22:27] Verifying running processes ...[170307 22:23:14] BEGIN 200_pre/501_recovery.sh[170307 22:23:51] http server is ena...
Presence server shows correct device MAC, but in the wireshark trace I switch to deskphone I see a SIP register with the old device name SEPXXXI rebooted both CM and CUP
The problem I found way UCCX 8.x does not like upper case file names. So if you named the file Test.WAV or Test.Wav it would not upload, but test.wav would.If you use my script with lower case file names you will be fine.
If you look at my script it authenticates the same way yours does,I tried yours and it I get the same when it runs the upload functions..just dies and kills the script.
