About anthony.dyne

anthony.dyne · 02-14-2013

Hi New WLC 5508 is shipped with software 6.0.199.4 and would like to upgrade to 7.x versioncan I upgrade directly to version 7.x from my current version and via GUIthannk youAnthony

anthony.dyne · 07-16-2012

Hi ExpertsNot able to register AP Point < Air-Cap35021-E-K9 > on 4402 WLC running IOS (AIR-WLC4400-K9-7-0-235-0 ) Other AP already registered on the WLC are AIR-LAP1242AG-E-K9 & AIR-LAP1131AG-E-K9Any hints to resolve the registration issuethanksAnt...

anthony.dyne · 05-28-2012

HiFor an IPSEC over GRE Tunnel is it adviced to have tunnel config on Internet Router and IPSEC on firewall also considering that UserVPN will be configured on ASA, internet browsing for LAN users, Email traffic will flow inside-to-outside and vice...

anthony.dyne · 05-28-2012

Hi AllCan someone explain me what these statements are there forThe config is from our MPLS router located in HeadOffice^controlled-ospf ^ whats its function^ routes_in ^ whats its functionhow to change standard acl to extended aclrouter bgp 4550 no ...

anthony.dyne · 05-07-2012

Hello AllI got WLC 4402 running version 4.2.205.0 and need to understand which next version i can directly upgrade. cheersAnthony

anthony.dyne · 02-14-2013

Thanks Scott ; can i upgrade via GUI or it has to be via TFTPyou advice which software version is stable for now7.2.111.3 7.3.112.07.4.100.0I see this msg while downloading 7.4.100.0WLC Version 7.4.100.0 will need Prime Infrastructure Version 1.3 t...

anthony.dyne · 07-17-2012

HiNot able to configure static IP even powering ; only get following msgMar 1 00:12:56.326: %CDP_PD-2-POWER_LOW: All radios disabled - NEGOTIATED WS-C2960S-48LPS-L *Mar 1 00:13:02.983: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not h...

anthony.dyne · 07-17-2012

can I enter static ip from AP consoledo I need any config for power on the switch, currently i have three POE device on the switch WS-C2960S-48LPS-LPOE1#show power inline Module Available Used Remaining (Watts) (Watts) (Wat...

anthony.dyne · 07-16-2012

Hi leoare are show commands(Cisco Controller) >show sysinfoManufacturer's Name.............................. Cisco Systems Inc.Product Name..................................... Cisco ControllerProduct Version.................................. 7.0.235...

anthony.dyne · 07-16-2012

on the console I dont see anything, do I need to enable some commands to get console output. which debug commands will help to identify the issue

Member Since	‎08-02-2010 01:45 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	144
Total Helpful Votes Received	5

User Statistics

User Activity

upgrade advice

AP Registration Issue

IPSEC

BGP statements

software upgrade

Re: upgrade advice

AP Registration Issue

Re: AP Registration Issue

AP Registration Issue

AP Registration Issue