Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In normal mode, all Incoming calls are going to the FXO using the connection plar voice-port 0/1/2trunk-group ALL-FXOcptone CAconnection plar opx immediate 112397caller-id enable dial-peer voice 5400 voipdescription FXO - Outgoing to CUCMdestination-...
Our IVRs are down, calls are not going to the IVR because the CUC trunk has no service (503). We have a cucm cluster.Site 1CUCM Pub and SubCUC pubSite 2CUCM subCUC sub Site 1 is down - The CUCM group works but I'm seeing the CUC sip trunk didn't fail...
We'd like to be ready for any unexpected event when we request to release it from the portal. I know that it has CME and CUE. And it also has fxo modules so I'm guessing it is running as gateway too? Does anybody have experience to manage and configu...
Phones keep disconnecting from the call manager and registering back for 3-5 seconds. Calls are affected, audio goes silent for about 3-5 sec (one or two way). We've checked our network monitoring system and we didn't find any issue with the networ...
I'm getting an issue in fxo lines in the isr. Found in vpm signal log about "fxols_power_denial_detected" on outbound call.Also, ring detection is shown on show voice port summary on inbound call. I added the command no battery reversal and no superv...
Sorry my mistake, I didn't explain my config clearly. *This is a SIP SRST fallback*5400 is a phone extension During normal operation-Calls are coming in to ISR (using the config above)-Then to the CUC to hit the IVR During SRST fallback (Network iss...
I've added another server IP in the Port Group>Servers and once clicked save, it shows 0.0.0.0. It's not letting me add a new IP. Also, the system is saying "One or more port groups need to be reset.".Don't know where to reset it, the button "reset" ...
Sorry not sure what information to provide.-CUC pub and sub are integrated using sip trunk-SIP is the port group type-24 port created for Site 1 CUC pub-24 port created for Site 2 CUC sub Thank you for pointing me to that location, I think i may know...
Site 1 server issue have been resolved. CUCM pub and sub, CUC pub are now back online. I hope to still fix the issue about the CUC fail over not working. Please help
