Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Easy question. The release notes for 3.3.3 say service pack 1 is supported, no mention of SP2. I've got two ACS servers that simply will not answer radius requests from a packet level and the logs show it never even heard them.The only thing in com...
This is a VERY simple setup. The ASA is running in transparent mode with an inside and outside interface. The ACLs allow ip and icmp any/any. But every couple of minutes you cannot ping through the ASA. The 1800 router goes out to a WAN.1800RTR--...
If using arrowpoint cookie balancing to stick a client to a particular service during the session what happens if the client doesn't send the cookie? There's an application that does this when looking at a trace on the client side:1) start TCP conn...
New commands were added to 6500 IOS SXF6 to ease initial setup of the trunk and channel ports for the wism. Problem is after typing these commands I can't undo them. This is the "wism module <mod> controller 1 native-vlan" command.After removing t...
It's a 6509 with sup720/pfc3b. If I try to create a second monitor session the error returned is "local span limit has been exceeded"I thought the sup720 supported two local span sessions?-----LAB6509#sh monitorSession 1---------Type ...
It looks like the wireless lan services module WLSM (what is in slot 1) creates a monitor session on it's own for some reason. I did not configure or create that one. Looks like it has something to do with multicast traffic.This monitor session can...
Thanks for all the input. Glad to know weren't the only ones facing this.Our head active directory guy talked to microsoft. Here's the recommendation:Apply Microsoft hotfix and set registry key to delay policy application.So we'll try that and see ...
Thanks. So is this a known issue with 2000 and wireless/802.1x?These are Dell workgroup bridges for each machine, so maybe that's the problem. The supplicant. For the most part we've been moving away from the funk supplicant and using the one incl...
I just use the same IP address on the tunnel interfaces. Works like a champ.If you have redundancy configured properly (you can check with "show mobility stat" on sup720) you will not get any duplicate IP errors.The tunnel interface on the primary 6...
