Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I do have created a VPN tunnel. My internal IP address is from 172 range and remote end IP address is from 192 range. Now I would like to configure this VPN tunnel in such when any IP address from 192 range is accessing servers in 172 ran...
I am confused about using reflexive ACL in my network. As per Cisco reflexive ACL will filter outbound traffic on the upper layer and deny any IP traffic coming inside the network. But I do have Webserver and iNotes servers hosted in my DMZ, these se...
Hi Experts,I want to gather as much information as possible about Stacking Cisco switches, be it GigaStack or Stackwise(Hope I've used the right terms, I am a novice when it comes to stacking).Could someone please advise.Many Thanks.
Hi Experts,I have always had this ques in my mind and wanted to clarify...When we do a show interface on a router for a V.35 serial interface, the interface bandwidth shows as 1544 Kbps...is it because these routers are manufactured in the US and are...
What I understand by you question is u want do dynamic nat in FWSM and it is possible if u are using single contaxt mode.Offcourse nat will be there for any PC which is connected on VLAN 55.And this will work only if ur initiating the connection from...
Hi,Thanks for the valuable information. I'll go through the link and try to grasp as much as possible.Practically speaking, how many switches do you think can be max in a stack.Best Regards.
Hi ,Cant we run a separate HSRP instance for the Tunnel interfaces on Router B and C and use the HSRP VIP as the tunnel destination on Router A. Regards.
