Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Something just struck me as I'm about to implement a design and it seems rather silly but I've never done it before. If I have a network that goes roughly like this:router A --> router B ---> switch ---> router C --> router DI'm running OSPF, would t...
Essentially, I'm trying to extend a analog line from a Nortel PABX across a data network to a slightly out of reach phone. I have 2 routers (2801) equipped with FXO and FXS cards each. I want to extend a analog line (RJ11) from the PABX to the route...
I can't seem to figure out what is the practical difference and what are the consequences of using multiple secondary IP vs creating multiple logical interfaces?I was wondering if this would bother my router's VoIP functions in anyway?
Consider me mostly a newbie. I have a router that's connected to a WiFi radio system. The radio is, for all intent and purposes, transparent to the network.Point is now, I want to connect via the same WiFi radio system to 4 other routers (each other ...
Ah, I switch to a fresh port and reconfigured everything and it work!Proceeded to wipe out the previous configurations and dial-peers and started over with a fresh slate. I had a strange moment when the dial tone from the PBX seems to be busy for 30 ...
Hmm... I actually did this. The problem I had is that while the call from PBX to phone works well. When I pick up a phone from the remote site to call an extension, all I get is an immediate ringing tone (unsure of what number its dialing). I though ...
I suspected as much, but the diagram and the config example from the site was so promising. My problem is that there's going to be multiple phone connected on the remote site, each with a corresponding line to the PBX. I'm having problem creating a P...
Silly me. My PLAR connection did not match. However, fixing that, and setting PLAR connection on the remote router, whenever I pick up the phone on the remote site, it immediately starts dialing/ringing. Does not wait for dialing. Calling to the remo...
If you don't mind, could you share the specifics of the configurations? What I have at the moment is 2 routers back to back, connected via fastethernet instead of serial as in the picture. No routing protocol is setup at the moment, but it will once ...
