About Nukesquad

Nukesquad · 05-03-2007

Something just struck me as I'm about to implement a design and it seems rather silly but I've never done it before. If I have a network that goes roughly like this:router A --> router B ---> switch ---> router C --> router DI'm running OSPF, would t...

Nukesquad · 03-13-2007

Essentially, I'm trying to extend a analog line from a Nortel PABX across a data network to a slightly out of reach phone. I have 2 routers (2801) equipped with FXO and FXS cards each. I want to extend a analog line (RJ11) from the PABX to the route...

Nukesquad · 07-31-2006

I can't seem to figure out what is the practical difference and what are the consequences of using multiple secondary IP vs creating multiple logical interfaces?I was wondering if this would bother my router's VoIP functions in anyway?

Nukesquad · 07-26-2006

Consider me mostly a newbie. I have a router that's connected to a WiFi radio system. The radio is, for all intent and purposes, transparent to the network.Point is now, I want to connect via the same WiFi radio system to 4 other routers (each other ...

Nukesquad · 03-20-2007

Ah, I switch to a fresh port and reconfigured everything and it work!Proceeded to wipe out the previous configurations and dial-peers and started over with a fresh slate. I had a strange moment when the dial tone from the PBX seems to be busy for 30 ...

Nukesquad · 03-18-2007

Hmm... I actually did this. The problem I had is that while the call from PBX to phone works well. When I pick up a phone from the remote site to call an extension, all I get is an immediate ringing tone (unsure of what number its dialing). I though ...

Nukesquad · 03-18-2007

I suspected as much, but the diagram and the config example from the site was so promising. My problem is that there's going to be multiple phone connected on the remote site, each with a corresponding line to the PBX. I'm having problem creating a P...

Nukesquad · 03-18-2007

Silly me. My PLAR connection did not match. However, fixing that, and setting PLAR connection on the remote router, whenever I pick up the phone on the remote site, it immediately starts dialing/ringing. Does not wait for dialing. Calling to the remo...

Nukesquad · 03-15-2007

If you don't mind, could you share the specifics of the configurations? What I have at the moment is 2 routers back to back, connected via fastethernet instead of serial as in the picture. No routing protocol is setup at the moment, but it will once ...

Member Since	‎07-13-2006 12:34 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	19

User Statistics

User Activity

Routing through a switch.

VoIP connection to PABX

Any disadvantages of using secondary IPs?

Creating multiple point to point connection

Re: VoIP connection to PABX

Re: VoIP connection to PABX

Re: VoIP connection to PABX

Re: VoIP connection to PABX

Re: VoIP connection to PABX