Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, does anyone know how to recover from a crashed rommon?The Sup720 goes directly to rommon on boot up but i'm unable to issue any commands.System Bootstrap, Version 7.7(1)Copyright (c) 1994-2003 by cisco Systems, Inc.Cat6k-Sup720/SP processor with ...
outside = 10.10.10.1 /24inside = 172.16.0.1 /24Dmz = 192.168.0.1 /24nat (inside) 0 0.0.0.0 0.0.0.0If i have a connection established from an inside host (172.16.0.100) to an outside server (10.10.10.50) will i need to issue the clear xlate command if...
Hi Jason, unfortunately i cannot test this now as the sup card is already on it's way back to cisco. However when the card was in the production chassis i switched the console cable between active sup and failed sup and the active sup worked with hy...
The problem is a corrupted rom monitor image and as it's firmware the whole module needs to be RMA'd. Although it may be possible to have a ROM device shipped and replaced on site.
Hi Satish, Thanks for reply but unfortunately it is of no use.Perhaps my original question wasn't clear enough.I'm cannot issue any commands at rommon.I cannot type anything it has crashed in rommon mode, if i hit return nothing happens. This is not...
