Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI, i am a lil confused...we have a Crypto ipsec / isakmp VPN tunnel setup from one router in the head office(loopback address) to the other router at the branch office(loop back address).Ospf routes are also configured.. and hello packets are being ...
Hi,I have the head office and the branch office connected via DSL (thats a Data circuit only , no internet) both sides have private IP on the DSL interface given by the ISP. i applied a preshard key method vpn on them to enable the LAN on both sides ...
I recently upgraded a Cisco2801 router from c2801-adventerprisek9-mz-124-3to c2801-adventerprisek9-mz.124-16the router has a Flash of 64MB. i deleted the old IOS befor i uploaded the new once ( cause there wasnt any space left.) the flash is now alm...
Im running Cisco 877 and 837 on my branch offices... both connec using ADSL lines to the same ISP at 256Kbps and 128Kbps respectivelyBranch1 seems to run noticably slow, can anyone please help me understand the following parameters of sh dsl int atm0...
so if i use dynamic routing between the branch and the head office ??? then that would cause the floating static route to work ???right ?let say i take out the ip route 0.0.0.0 0.0.0.0 192.168.28.250 and configure EIGRP but then id have a problem.. i...
Thanks Rick..that cleared up a lota things Im using EIGRP as of now... can you please check the backup configuration that ive configured using the dialer 0 for ppoe dsl connection...cause i ran a test today bu powering off the radio bridge .. ideall...
check what ip do u get while using the sprint mobile broadband card.. ? public or private..?. my GRPS provider sets a 10.10.x.x ip scheme on the connection....cause the way i took it was its like connecting vpn client while sitting behint a NATTING ...
