Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a WLC-4404-100 with a mix of c1131 and c1232 access points associated. All my AP's are LWAPP (either ordered as LWAPP or converted from IOS to LWAPP), and I have just realised that I have more than 100 AP's to be rolled out. I know that an L...
I am having problems getting H.323 video calls to route out to the PSTN using a Cisco IP/VC 3527 ISDN Gateway. I have the ISDN Gateway configured with a service prefix of 82 to route calls out to the PSTN with the correct video settings. However, whe...
Before I start, let me say I don't know much about IPCC and I know next to nothing about Historical Reporting. I have a customer who has come to me with problems on their IPCC server and has said they are getting errors/differences in their reports w...
I am having a couple of problems with CallManager Express 4.1. My first issue is with MWI using Unity Express (2.3.2). When I leave a voicemail for a phone, the MWI is not turning on. The phone gets no visual indication that a voicemail has been l...
I am having problems getting multiple VLANs to carry across a bridged point-to-point link. I have a portable building that has no wired infrastructure and have had to run a wireless bridge link from the portable back to a main building. Also, in th...
I understand how to carry out the conversion process, my question is related to the configuration of the AP after it has been converted. When it first boots up in Autonomous IOS mode after being converted from LWAPP, what is the configuration of the...
Thankyou. I added the sip-ua and mwi-server lines, then changed the ephone-dns to "mwi sip" and now my MWI problem is fixed and working. Appreciate the help on this.
You will have to excuse my knowledge, or lack there of it.My system is a totally IP system that is not connected to the PSTN at all. It is being used as a seperate internal phone system across the corporate network for private communications between...
Thanks for your reply.I added the incoming called number 800... to the dial-peer voice 2 voip but it still does not light up the MWI on the handset.If I manually call 800102, it will light up the MWI for extension 102. Then if I call 801102 it will ...
Here is the version information I have gathered:MeetingPlace Audio Server 8106 software version 5.3.0MeetingPlace Video v5.3.0.13MeetingPlace Gateway v5.2.0.52MCU Unit v5.0.0.0.58MCU H.323 Stack v4.2.2.3MCU MIB v4.2.0.6Good to see I'm not the only on...
