Realize you were responding to another post, but in our case we dealing strictly with h.323 gateways.We still do not have a workaround for our gen 1 or gen 2 ISR's.

I'm running into the same issue.  What's nice about the POP MIB is that it gives you DS0 utilization on an DS1 basis, so you can verify load distribution and perform proper capacity planning.  As others have found, though, it only works with VWIC's i...

That will allow any host on the Internet using a TCP source port of 20 unrestricted access into your network.Jarred

The link is up now:http://www.cisco.com/en/US/products/hw/switches/ps5023/products_data_sheet0900aecd80371991.htmlJust for the sake of clarity - "The 48-port versions can deliver the necessary power to support 24 ports at 15.4W, 48 ports at 7.7W, or ...

Bruce,Everything you mentioned regarding the map-class is correct. With regards to the application of the policy you actually have two options. If all of the remote sites are identical regarding the frame-relay parameters AND the voice requirements...