Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,
Im looking for ways to see top actual bandwidth users on the network by source ip/login name to dest addresses / by application.
We have a Cisco ASA 5508-X and 2960X access and 3850 core switches.
What would be the best optimal way to mo...
Hey all,
We have upgraded our anyconnect VPN to version 4.2.030013 ever since we can not connect to sites which has version 3.1.05182. Users can not connect to these sites this is the error massage they get:
"Connection attempt failed. Please try aga...
Hey folks,
I have a really strange issue with my 2960X switch that operates in PVST+ and that is connected to a Cisco SG300 and SG500 unit.
For some reason each device dose not recive any BPDU but they send it to each other.
Have tried set manually...
Hi all,
We are seeing the following syslog massages when we are trying to authenticate via the ASA:
Non-HTTP connection from outside:10.100.100.1/51253 to inside:192.168.76.13/8905 denied by redirect filter; only HTTP connections are supported for ...
Greetings,
We have an ASA 5525 (9.4.3 IOS) and an Aruba ClearPass server. We terminate an IPSec remote VPN on the ASA with RADIUS authentication and then a NAC checking from the ClearPass server.
The RADIUS and the NAC process is successful but aft...
Hello Dina,
The problem exists on the Cisco ISR router which has version 3.1.05182 of anyconnect.
I have run this command "debug webvpn" but the out put has no useful info in it:
Jul 27 09:22:00.380 CET: WV: Tunneled data packet was sentJul 27 09:...
Hello Jouni,Yes, we have this command on the router:management-access insideAnd yes. The local inside LAN interface IP address is: 10.0.0.1 The 10.0.2.71 IP is the address of the PC from the site to site VPN's end inside the lan.Than each time we try...
