Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
>> Getting below logs from 9500 stack switch .>> Seems all the traffic are going out this link. please find the below output>> it will problem in further .Port Lane (dBm) (dBm) (dBm) (dBm) (dBm)--------- ---- --------------- ---------- --------- ----...
In my organization we have using Cisco Anyconnect for Remote access & split tunneling option its enabled.0.0.0.0 -> Non secured router 10.0.0.0/8 > secured routesits mean only 10 network traffic should go via ASA box & apart from all other traffic sh...
Between the ISR Router ISR4331, I have configured IKEv2, but the tunnel comes up.Setup like HUb and spokein the HUb router more than 35 tunnels are there, am facing issue with only one site. Logs collected from spoke router :Apr 15 12:32:03.188: IKEv...
For 9800 wireless controller i want to connect multiple Flex connection Access points , its possible i can use the same for that, in all the we are using different native vlanFor example : 1st site : 1002nd site: 2003rd site: 300 Kindly let me know i...
If i check the transceiver on specific interface , getting result like below : not getting any values Optical High Alarm High Warn Low Warn Low AlarmReceive Power Threshold Threshold Threshold ThresholdPort Lane (dBm) (dBm) (dBm) (dBm) (dBm)--------...
LX and SX it will support for above setup right. i what to know what type SFP i need to use in the both end [2960 & 3560]Devices are sites very near by only
Thanks for the update..For example :i will remove the 2950 switch from network & connect the 2960 switch with new fiber cable with WS-C3560CG-8PC-S.[ with multimode fiber ] then it should work right? completely am planning to lay the new cable i what...
