Good day, I'm studying prefix list and I seen in several documents that they use a prefix list for RFC 1918 to explain the use of prefix lists, the list is the following:ip prefix-list RFC1918 seq 5 permit 192.168.0.0/16 ge 32ip prefix-list RFC19...
Good day, I'm studying BGP and seeing the neighbor X activate and the no neighbor X activate. I'm reading about the reason for neighbor X activate but haven't seen the reason for the no neighbor X activate. Why do we need to deactivate the IPv6 n...
Good day, I'm seeing the SBS350 24P + 4 x 10GB SFP+ port and I don't see anywhere if I can connect a 1GB SFP to the 10 GB SFP and it will work. I read some online information and it says it should but I don't know if I can find some documentation t...
Good day, I'm trying to do a bulk modification of users data in a Cisco ISE. We're migrating from an ACS to and ISE and I've migrated all the TACACS users from one to another. All the users are disabled because of the password policies and have t...
Good day, I'm having an issue when I use the enable command having and ISE as AAA. If I enable the external auth for the enable I receive the following log:13029 Requested privilege level too high I'm configuring the aaa authentication enable ...
Good day, Thanks for answering @MHM Cisco World . Yes, using the ge /32 for permitting only the hosts is correct, the issue is with the 2nd lineip prefix-list RFC1918 seq 10 deny 0.0.0.0/0 ge 32 This one blocks all the traffic for all the othe...
Yes, since ge means greater or equal than I get that it means all the /32 or hosts but since le means less or equal than the le /32 contains the ge /32 because there is not any mask greater than /32. That's why I doesn't understand sequences 5 and 10...
I testes the Prefix list in GNS3 and it works as I said, not as it should regarding the documentationWith the prefix list activated R2#interface Loopback0ip address 172.16.50.1 255.255.255.255ip ospf 2 area 0 From a PC connected into R1 to the lo0 of...
Good day, Thanks for answering @MHM Cisco World , that example is in the official updated documentation on the Cisco CCNP and CCIE Encore book and in the CCNP ENARSI book. That's why I'm asking because in both updated book they use the same examp...
