Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the following issue with a MGCP Gateway running 12.4.15T7 and CM 4.1.3sr4bCaller ID Outbound for Local calls does not work and displays on remote phone as unknown.However, Outbound callerID is working for Long Distance callsContacted Provider ...
I have a question I would like to clarify.I'm working with a UC500 system for 24 users max. The customer would like to cut some conferencing cost and host the conferences locally by utilizing the new UC500 that will replace the current PBX. Current...
I have a Unity 4.0.3 server that needs to be migrated to version 7.X in a VMWare ESX server infrastructure. I will follow the same procedures to upgrade the server from a physical perspective,(like if I was doing another physical box, COBRAS). Howev...
Hi everyone,Will Unity digital networking work in the below scenario?CallManager version 5.X withUnity VM Only version 5.X with local exchange 2003 digital networked to another Unity version 5.X connected to a Nortel via PIMG?The requirement here is ...
I got mobility working with CM6, however the end users would like to reach the cell phone voice mail and dont come back to the deskphone for voicemail.(keep the message at the cellphone) I've tried multiple combinations of the timers Answer Too Soon...
Konrad,Thanks for your time. Here is what I have tried1. Under the Gateway MGCP PRI PortCall Routing Information - Outbound CallsCalling party IE number type unknown: NationalCalling Numbering Plan: ISDNPlaced outbound call 7 Digit to Local Number. ...
Can you please post the whole config? make sure you have ccm-manager fall-back mgcp!applicationglobalservice alternate Default!Looking at your whole config will be better.Armando
Rob,Thanks for your time. The conference idea is supposed to be taking place one time maybe once a month. Customer knows about the number of channels (PRI) and possible results if they are all in use by conferencing (design). I just wanted to conf...
Never done the SMA, but I have change IPs and hostnames in MPE (single server) without any issue. I have update DNS to reflect the updates and all worked fine.However, in our case you may need to re-apply the license and perform a reboot of both MPE...
Yes, The relay worked.MPE uses the STMP setting and in Exchange 2007 the relay setting can be configured for IP or email address for relay authentication depending in how the exchange admin wants to do it.hthArmando