Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we have a receptionist who answers multiple incoming 800 numbers.. other than associating them to an extension, is there a way for one extension to list what incoming line the line came in on so she knows to answer correctly?ie, 800-444-1111 comes in...
I went to use that funky new explorer like interface that cisco put on the switch downloads (what was wrong with the directories? was that too complicated for someone?) I personally found the old file directory worked much better.and the attached scr...
I have a cm cluster, unity and ipcc that were installed in early '04 and haven't been touched since.. I've been running thru the patches.. numerous..the cm are at 4.0(2)sr2a and I'm going to 4.0(2)sr2c, unity to 4.0.3 to 4.0.5 and also cm-tsp to 8.1....
We have two 3745's we like to use as redundant h323 gateways. Also use xmedius (hence the h323)Can someone point me to a doc or explain the best way to set up redundant gateways with callmanager. we have two local t1's and two long distance pri's so ...
One of my vendors is telling me that with pre-standard power a WLC cannot control the antenna power settings of the 1130/1200 series access points. Does anyone know if this is true or not?
Cisco has ibmitis now... you ask what that is? well it's environment that says "We're big, we don't have do to do anything easy or simple now because we've got 'em hooked"Forgetting that the reason why everyone used Cisco was that it was easy and sim...
I disable inline power because I've had hp printer cards cause alot of squawking in my syslog. but then again, I disable everything, including unused ports and run port security(really drives 'em crazy that they actually have to tell me when they are...
David, you need to shut unity down, go into your control panel and set the time zone to any other time zone, close and re-open, set to the correct time zone, restart unity.. then your tui interface will say the correct time.
rebooting unity didn't do a thing.. but what did work was shutting down unity, changing the time zone to anything else.. then setting it back properly to the right time zone and restarting unity.. everything worked properly after that.
per cisco tac, jre is only for the pca interface.. would have nothing to do with time stamping on msg's,thats between exchange and unity. I'm off to the reboot fairy tonight. see if that solves the issue.
